Modus W Series Pressure Transmitters PSI 0 to 75 kPa 1 hole

The Modus W Series pressure transmitters are designed to measure low differential pressures of liquids or gases. A wide selection of standard pressure ranges and electrical ratings is available.

These pressure transmitters feature: no moving parts to wear out, proven long term stability of piezoresistive devices, and all welded construction. Only 316 stainless steel is in contact with the fluid.

Series W pressure transmitters are an excellent choice for many HVAC, process and automation monitoring requirements. Typical applications of these pressure transmitters include measurement of differential pressure across flow elements, heat exchangers, pumps, filters, liquid level monitoring and other demanding differential pressure measurement and control applications.

The Modus W Series transmitters are housed in a compact cast aluminum enclosure with heavy duty gaskets, designed to IP 65 of IEC 529 standards and NEMA 4. The die cast aluminum enclosure incorporates a recessed neoprene gasket to prevent ingress of moisture or dust. Wall mounting holes are enclosed in the cast aluminum box and concealed by the cover. The wall mounting holes and the cover attaching screws are outside the gasket area. Access to these pressure transmitters' electrical terminals are made through a knockout on the front of the box. One knockout is standard with three hole sizes available to accommodate usage of 1/2 inch conduit or metric sizes PG11 and PG13.

The span or zero adjustment is performed with a 20-turn potentiometer for fine resolution. A 50% adjustment in output is possible. The Modus W Series pressure transmitters have been tested by an accredited laboratory and comply with the European requirements of Council Directive 89/336/EEC for emission measurements per EN50081-1 and immunity tests per EN50082-1.

Modus W Series Pressure Transmitters Operation:

These pressure transmitters consist of two high accuracy piezoresistive sensors with stainless steel isolation diaphragms. Both sensors measure static pressure and the difference between these two measurements is computed electronically. The use of high accuracy and stable sensors makes this measurement possible. Since each sensor measures the full static pressure, there is no possibility of over-pressurizing the transmitter if one sensor is disconnected from the line. No complex and expensive balancing valves are needed.